I discovered LineageOS a few days ago and wanted to give it a try.
I an using:
- Raspberry Pi 4 B+ 2GB
- 7 inch DSI screen with capacitive touch (similar to WaveShare)
- Booting from USB 3 stick
In the config.txt I activated:
dtoverlay=android-usb
dtoverlay=vc4-kms-dsi-7inch
dtoverlay=rpi-ft5406
Everything else is unchanged.
The setup went pretty good. But now when I click for instance on Settings, I get about every 2-3 seconds "Settings isn't responding". I cannot even type in the WiFi password because of this. It pops up continuously and it's behind the keyboard... After a reboot it got even worse: "System UI is not responding", "Trebouchet isn't responding", "Process system isn't responding".
That's all I can get out of it... Any ideas what's going wrong here?
I an using:
- Raspberry Pi 4 B+ 2GB
- 7 inch DSI screen with capacitive touch (similar to WaveShare)
- Booting from USB 3 stick
In the config.txt I activated:
dtoverlay=android-usb
dtoverlay=vc4-kms-dsi-7inch
dtoverlay=rpi-ft5406
Everything else is unchanged.
The setup went pretty good. But now when I click for instance on Settings, I get about every 2-3 seconds "Settings isn't responding". I cannot even type in the WiFi password because of this. It pops up continuously and it's behind the keyboard... After a reboot it got even worse: "System UI is not responding", "Trebouchet isn't responding", "Process system isn't responding".
That's all I can get out of it... Any ideas what's going wrong here?
Statistics: Posted by Hermann — Sun Jul 05, 2026 4:28 pm





